![]() If the above does not correct anything then, it could be that electrical signals are becoming corrupted somehow. Make sure to delete any temp files, the folders and anything related to UPStudio. ![]() I would also check the sd storage card on the printer. This may correct the errors you see within UPStudio, and also any IO to the printer. I would run a diagnostic to check your hard-drive/s files for errors, and also include the check for unused spaces for physical errors. UPStudio program files might be corrupt on your computer hard-drive, or the temp files UPStudio uses might be corrupt. I’m feeling a bit ignored right If somebody here has any idea what else I could test, I would much appriciate it.īest, I viewed your videos, and although I have not experienced the same events, I have a few thoughts that may help you. Jason Wu only reacted once to the inital request but never came back to me after I sent him the videos, although I send daily reminders to Please respond to my emails or this forum post. I already have opend a ticket for Tiertime Support (16546) on Jul 2. I basically can not use the printer anymore at the moment. Removed the extension board and heated bed and used the original configuration. All Pins OK, reseated all connectors + tested with multimeter. Checked all motor cables + end stop cables. “Clear Cache file” + “Clear downloaded models” in UPStudio Connecting printer via USB instead of WiFi I tried following things but nothing helped: Printer is initializing immediately after turning it on and then doing random moves… Really strange. X axis is crashing in end of axis! But it only happens sometimes, sometimes not… “ Model Out of Print Range” in UpStudio although its clearly not! “ Motion System Error Z” in UpStudio (sometimes I also get “Motion System Error” for X and Y axis as well…) ![]() In the video you can see following problems: I made four short videos to show you the problems. I turned off the printer and wanted to see if I have better luck the next day… It always stoped at some point in the print with “ Motion System Error Z”. I had to throw away the print and start again.īut I could never finish the print (1-2 hour print time). I could not resume the print and UpStudio shows me a “ Motion System Error Z” error. Later that day Cetus just stops in the middle of the print, drives the z axis to the top and stops. It started with the Cetus making random “beep” sounds from time to time. I even got the extension board, 24V psu, heated bed and auto probe later, all working fine.īut now since last week I got some very strange problems out of nowhere! It worked perfectly fine and produced nice prints without any fiddling around. I bought a Cetus MK3 half a year ago as my first 3D Printer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |